![]() To improve the lifespan of your cartridges follow these simple tips: Want to maximise the lifespan of your cartridges? If you purchased your from us within the last 3 months then please contact us for a replacement under your MagicMist Warranty. Batteries are a consumable component, but should last 3-6 months. If the battery still doesn’t work then it’s probably reached the end of its life. When charging or attaching cartridges, we recommend that you don’t screw the battery on too tight. Going around the centre piece a few times should lift it up. Hold the pin at an angle and try and lift up the centre piece. Place a pin or needle in the space between that centre-pin and the thread walls around it. If the battery still doesn’t work, then its centre-pin that connects to the cartridge may have been pushed in too far by being screwed tightly onto chargers or cartridges. Use this point to clean any hard to reach areas in the screw thread and around the battery contacts. If there is any other residue, get a piece of paper and roll it so that one end has a point. To ensure the battery does not get damaged by the alcohol, do not soak the cotton-bud with alcohol, just keep it damp. Use a cotton bud dipped in rubbing alcohol to swab the threads and contacts of the battery. Then leave the battery to dry for a day or two. If so, shake the battery (thread down) to try and discard any E-liquid. If you fill your own cartridges, potentially you could have overfilled and this could enter the battery. If there is any E-Liquid, use a tissue or cotton-bud to clean and dry the battery. If the cartridge or clearomiser does work with the new battery, then there is an issue with your current battery we can try and resolve below.Ĭheck the screw thread end of the battery to ensure it is clean and dry. If you still don’t get a good quantity of vapour, then the cartridge or clearomiser has reached the end of its life. If the cartridge or clearomiser still produces low or no vapour, check it with a battery you know is charged, now you’ve removed any blockages. When it gets hot it should vapourise anything that’s clogging it. You’ll feel the cartridge becoming warm as it heats up. If the issue is still not solved, put the usual end of the E-Cig in your mouth and blow hard into the cartridge. Then put the usual end of the E-Cig in your mouth and suck air through 2-3 times. Blow hard 2-3 times down the battery – you should see vapour leave the cartridge. Then clear the air passages by re-attaching the cartridge to the battery and placing the LED end of the battery in your mouth (the side you don’t inhale from). This should un-settle any dried E-Liquid. Tap it forcefully, thread-side down, on a hard surface. ![]() If you have a regular E-Cig, unscrew the cartridge from the battery. If you have a vapouriser device (such as an Ego, Evod or iTaste), unscrew the clearomiser from the battery and blow hard down the mouthpiece to clear any air bubbles in the E-Liquid. Remove Cartridge or Clearomiser Blockages Otherwise check the battery’s light when you inhale – if it doesn’t come on or flashes quickly the battery has run out of charge.Ģ. Ideally try your cartridge or clearomiser with another battery – if it works you know the first battery is out of charge or defective.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |